Model AP-3530 3300-3800 MHz 30 dBi. Gain 
 

GRID PARABOLIC ANTENNA

Design Features: The AP-3530 microwave grid parabolic antenna uses 6063T6 ultra corrosion resistant architectural anodized aluminum alloy and is consists of full Parabolic reflector having a diameter of 1.2 Meters for use in point-to-point analogue and digital communication systems. The mounting arrangement of grid parabolic Antenna permits to change the polarization from horizontal to vertical and vice-versa.

Constructions: Radiating elements and the dipole feed are made high quality aluminum alloy to avoid any dissimilar materials. The rim and supporting arc are welded with argon welding technique to provide smooth finish and strong joints. Each grid member of the antenna is riveted at four points using pneumatic riveter. All the screws, nuts, bolts and mounting hardware of grid parabolic antenna are made of type 316 marine grade stainless steel.

Tracking Mechanism: The AP-3530 microwave grid parabolic antenna supplied with elevation tracking mechanism where fine adjustments is necessary to optimize the signal strength of radio link.

Electrical Specifications:
Frequency Range3300-3800 MHz
Gain30 dBi.
Bandwidth500 MHz
PolarizationVertical or Horizontal
Input Impedance50 Ohms
Radiation PatternDirectional
Horizontal Beamwidth -Half Power Points5 Degrees
Front to Back Ratio26 dB.
VSWR1.5:1
RF Power Handling Capacity150 Watts
Input TerminationN-Female

Mechanical Specifications:
Materials6063T6 Aluminum Alloy
Mounting Hardware -MaterialsMarine Grade Stainless Steel
Wind Rating200 Km/Hr.
Diameter of Parabolic Reflector1.2 Meters
Reflector Grid Material Aluminum Tube 1/2 Inch
Support & Rim MaterialAluminum Tube 1 Inch
Maximum Mount Pipe Diameter 50mm - 76mm (2-3 Inches)
Gross Weight18 Kgs.

Environmental Specifications:
Operating Temperature(-)30 to +70 Degrees Celsius
Storage Temperature(-)40 to +80 Degrees Celsius
Humidity0 to 95% RH