Model: AP-85028 700 - 990 MHz. 28 dBi. Gain 
 

GRID PARABOLIC ANTENNA

Design Features: The AP-85028 grid parabolic antenna consists of full Parabolic reflector having a diameter of 4 Meters for use in all tactical and fixed station applications for terrestrial point to point analogue and digital communication radio link. The antenna covers 80 MHz bandwidth, operates in linear polarization and requires two operators for installation. The antenna dipole feed uses an Air-Cored transmission line. The mounting arrangement of Grid Parabolic Antenna permits to change the polarization from horizontal to vertical and vice-versa by mounting hardware fitted at rear end of the antenna. The antenna is supplied with +/-10 degrees elevation tracking mechanism. The grid parabolic antenna operates at D.C. ground with low resistance discharge path for protection against lightning and immunity to noise.
Constructions: The AP-85028 uses 6063T6 ultra corrosion resistant architectural anodized aluminium alloy and supplied with epoxy based anti-corrosive powder coating finish in order to prevent it further from severe environmental condition. The parabolic reflector is illuminated by a primary feed which is fitted to the center of assembly with quick fastener system. Radiating elements and the dipole feed are made of high quality brass. All the screws, nuts and bolts of tactical microwave antenna are of marine grade stainless steel. The antenna supplied with army olive green color.
Tracking Mechanism: The AP-85028 grid parabolic antenna is supplied with azimuth and elevation tracking mechanism where the fine adjustments is necessary to optimized the signal strength of a radio link along with 2 side struts to provide extra supports to the antenna.

Electrical Specifications:
Frequency Range700 - 990 MHz.
Gain28 dBi.
Bandwidth80 MHz.
PolarizationVertical or Horizontal
Input Impedance50 Ohms
Radiation PatternDirectional
Beamwidth -3dB.6 Degrees
Front to Back Ratio38 dB.
VSWR1:1.5
RF Power Handling Capacity250 Watts.
Input TerminationN-Female
Lightning ProtectionDirect Ground

Mechanical Specifications:
Materials6063T6 Aluminum Alloy
Mounting Hardware -MaterialsMarine Grade Stainless Steel
Wind Rating190 Km/Hr.
Support Pipe O.D.76 mm (3 Inches)
Support Pipe Material6063T6 Aluminum Alloy
Diameter of Parabolic Reflector4 Meters
Radiating MaterialHigh Quality Brass
Grid Members MaterialAluninum Tube 16 mm (5/8 Inch)
Maximum Mount Pipe Diameter 115 mm (4.5 Inches)
Gross Weight200 Kgs.

Environmental Specifications:
Operating Temperature(-)30 to +70 Degrees Celsius
Storage Temperature(-)40 to +80 Degrees Celsius
Humidity0 to 95% RH