Model: LP-1200-1600 1200-1600 MHz 11 dBi Gain 
 

HIGH GAIN LOG PERIODIC ANTENNA

Design Features: The LP-1200-1600 log periodic dipole antenna is designed to provide wideband directional transmission/reception of radio signals from 1200 to 1600MHz bands including GPS L1 and GPS L2 bands. The compact size of the log periodic antenna allows easy handling and specially designed mounting arrangement results in fast installation. The extra spacers are used between the support booms to improve mechanical durability of antenna. The log periodic dipole antenna is supplied complete in assembled condition. This high gain LPA provides strong performance over the entire frequency of 1200-1600MHz as the LPDA does not use loading technique to reduce the overall size of array. Powder coating of the complete log periodic antenna provides extra protection against corrosion in saline weather present in coastal areas.

Constructions:The high gain log periodic dipole antenna uses 6063T6 ultra corrosion resistant architectural anodized aluminum alloy with powder coating finish to protect the antenna further from severe environmental condition. The LP-1200-1600 assembled log periodic antennas outer-most dimensions are 0.45 meter (18 Inches) long and 0.13 meter (5 Inches) wide. The log periodic antenna operates at D.C. ground with low resistance discharge path for protection against lightning and for immunity to noise. Output of log periodic antenna is provided via low loss coaxial cable at the back end of the antenna boom. All the screws, nuts and bolts of log periodic dipole antenna are made of stainless steel.

Electrical Specifications:
Frequency Range1200-1600 MHz
Gain11 dBi
BandwidthEntire Band
PolarizationVertical or Horizontal
Input Impedance50 Ohms
Radiation PatternDirectional
Horizontal Beamwidth -Half Power Points50+/-5 Degrees Typical
Front to Back Ratio19 dB.
VSWRLess Than 2:1
RF Power Handling Capacity100 watts
Input TerminationN-Female
Lightning ProtectionDirect Ground

Mechanical Specifications:
Materials6063T6 Aluminum Alloy
Mounting Hardware -MaterialsMarine Grade Stainless Steel
Wind Rating200 Km/Hr.
Overall Length450 mm
Shipping Length500 mm
Support Boom -
Material - O.D.
Aluminum
Square Tube
Elements - Materials
- Cross Section - Outer Diameter
Aluminum
Round Rod
Insulator MaterialTeflon
Maximum Mount Pipe Diameter 30-52 mm (2 Inches)
Gross Weight2 Kgs.

Environmental Specifications:
Operating Temperature(-)30 to +70 Degrees Celsius
Storage Temperature(-)40 to +80 Degrees Celsius
Humidity0 to 95% RH