Model: LPDP-800-2000 800-2000 MHz 9 dBi Gain 
 

DUAL POLARIZED LOG PERIODIC ANTENNA

Design Features : The LPDP-800-2000 dual polarized log periodic antenna uses 6063T6 ultra corrosion resistant architectural anodized aluminum alloy. It is designed to provide wideband directional transmission/reception of horizontal and vertical radio signals from 800-2000 MHz bands. The extra spacers are used between the support booms to improve mechanical durability of antenna. The specially designed mounting arrangement results in fast installation. This dual polarized log periodic dipole antenna system is particular suitable for transmission, reception, monitoring, scanning and jamming applications due to its capability of receiving/transmitting both the E & H polarized signals simultaneously. This high gain cross LP provides strong performance over the entire frequency of 800-2000 MHz as the LPDA does not use loading technique to reduce the overall size of array.

Constructions : The LPDP-800-2000 assembled log periodic antennas outer-most dimensions are 0.5 meter (20) long and 0.2 meters (8 Inches) width & height. The antenna is supplied complete in assembled condition. The antenna is also supplied with powder coating finish to protect the antenna further from severe environmental conditions. The mounting hardware is permanently welded at the back end of the support boom eliminating the requirements of non-metallic isolated pole/mast. All the elements are welded at points along the support boom. The log periodic antenna operates at D.C. ground with low resistance discharge path for protection against lightning and immunity to noise. All the screws, nuts and bolts of dual log periodic dipole antenna are made of type 316 marine grade stainless steel.

Electrical Specifications:
Frequency Range800-2000 MHz
Gain9 dBi
BandwidthEntire Band
PolarizationVertical & Horizontal
Input Impedance50 Ohms
Horizontal Beamwidth -Half Power Points70 Degrees
Vertical Beamwidth -Half Power Points60 Degrees
Front to Back Ratio16 dB.
VSWR2.5:1
RF Power Handling Capacity250 Watts
Input Termination2 x N-Female
Lightning ProtectionDirect Ground

Mechanical Specifications:
Materials6063T6 Aluminum Alloy
Mounting Hardware -MaterialsMarine Grade Stainless Steel
Wind Rating200 Km/Hr.
Overall Length500 mm
Shipping Length800 mm
Support Boom -
Material - O.D.
Aluminum
Square Tube
Elements - Materials
- Cross Section - Outer Diameter
Aluminum
Round Rod
Insulator MaterialTeflon
Mounting Clamps PositionAt the rear end of boom
Maximum Mount Pipe Diameter 77 mm (3 Inches)
Gross Weight3 Kgs.

Environmental Specifications:
Operating Temperature(-) 30 to + 70 Degrees Celsius
Storage Temperature(-) 40 to + 80 Degrees Celsius
Humidity0 to 95% RH