Model: LPDP-1200-1600 1200-1600 MHz 11 dBi Gain 
 

DUAL POLARIZED LOG PERIODIC ANTENNA

Design Features: The LPDP-1200-1600 dual polarized log periodic antenna uses 6063T6 ultra corrosion resistant architectural anodized aluminum alloy. It is designed to provide wideband directional transmission/reception of horizontal and vertical radio signals from 1200-1600 MHz bands which includes GPS L1 and GPS L2 bands. The extra spacers are used between the support booms to improve mechanical durability of antenna. The specially designed mounting arrangement results in fast installation. This dual polarized log periodic dipole antenna system is particular suitable for transmission, reception, monitoring, scanning and jamming applications due to its capability of receiving/transmitting both the E & H polarized signals simultaneously. This high gain cross LP provides strong performance over the entire frequency of 1200-1600 MHz as the LPDA does not use loading technique to reduce the overall size of array.

Constructions: The LPDP-1200-1600 assembled log periodic antennas outer-most dimensions are 0.45 meter (20) long and 0.12 meters (5 Inches) width & height. The antenna is supplied complete in assembled condition. The antenna is also supplied with powder coating finish to protect the antenna further from severe environmental conditions. The mounting hardware is permanently welded at the back end of the support boom eliminating the requirements of non-metallic isolated pole/mast. All the elements are welded at points along the support boom. The log periodic antenna operates at D.C. ground with low resistance discharge path for protection against lightning and immunity to noise. All the screws, nuts and bolts of dual log periodic dipole antenna are made of type 316 marine grade stainless steel.

Electrical Specifications:
Frequency Range1200-1600 MHz
Gain11 dBi
BandwidthEntire Band
PolarizationVertical & Horizontal
Input Impedance50 Ohms
Radiation PatternDirectional
Horizontal Beamwidth -Half Power Points50 Degrees
Vertical Beamwidth -Half Power Points40 Degrees
Front to Back Ratio19 dB.
VSWR2.2:1
RF Power Handling Capacity100 Watts
Input Termination2 x N-Female
Lightning ProtectionDirect Ground

Mechanical Specifications:
Materials6063T6 Aluminum Alloy
Mounting Hardware -MaterialsMarine Grade Stainless Steel
Wind Rating200 Km/Hr.
Overall Length500 mm
Shipping Length700 mm
Support Boom -
Material - O.D.
Aluminum
Square Tube
Elements - Materials
- Cross Section - Outer Diameter
Aluminum
Round Rod
Insulator MaterialTeflon
Mounting Clamps PositionAt rear end of the boom
Maximum Mount Pipe Diameter 52 mm (2 Inches)
Gross Weight2.5 Kgs.

Environmental Specifications:
Operating Temperature(-) 30 to + 70 Degrees Celsius
Storage Temperature(-) 40 to + 80 Degrees Celsius
Humidity0 to 95% RHH