Model: LPDS-200-500 200-500 MHz 14 dBi Gain 
 

HIGH GAIN LOG PERIODIC ANTENNA

Design Features: The LPDS-200-500 is a set of two log periodic antennas stacked in horizontal (side-by-side) configuration with vertical polarization. The LPDS-200-500 dual stacked log periodic dipole antenna use 6063T6 ultra corrosion resistant architectural anodized aluminum alloy and designed to provide wideband directional transmission/reception of radio signals from 200-500 MHz bands. The specially designed mounting arrangement results in fast installation. The extra spacers are used between the support booms to improve mechanical durability of log periodic antenna. The antenna can be assembled in less than 10 minutes. This dual stacked log periodic dipole antenna system is particular suitable for transmission, reception, monitoring, scanning and jamming applications due to its broad band design feature. The dual stacked log periodic antenna provides typical 14 dBi gain over the 200-500MHz frequency band as the LPDA does not use loading technique to reduce the overall size of array hence provides the strong performance as compare to the loaded antenna or active antenna.
Constructions: Each LP-200-500 assembled tactical log periodic antennas outer-most dimensions are 1.4 meters (4.5 feet) long and 0.75 meters (2.5 feet) wide. The antenna has removable elements, the longest of which is 0.36 meter. All elements and support booms are supplied in two segments for easy of shipping and handling. The elements are attached via a fast deployment stainless steel studs & nuts system at points along the boom. The log periodic antenna operates at D.C. ground with low resistance discharge path for protection against lightning and immunity to noise. The complete antenna is supplied with powder coating finish to protect it further from severe environmental conditions All the screws, nuts and bolts of log periodic dipole antenna are made of type 316 marine grade stainless steel. The dual stacked LP antenna is supplied with horizontal stacking poles to install the antenna on both edges, central mast mounting brackets, suitable power splitter/combiner with phasing harness cables.

Electrical Specifications:
Frequency Range200-500 MHz
Gain14 dBi
Bandwidth200-500MHz
PolarizationVertical or Horizontal
Input Impedance50 Ohms
Beamwidth -3dB.25 Degrees - Azimuth
Beamwidth -3dB.50 Degrees - Elevation
Front to Back Ratio18 dB.
VSWR< 2.5:1
RF Power Handling Capacity500 Watts
Input TerminationN-Female
Lightning ProtectionDirect Ground

Mechanical Specifications:
Materials6063T6 Aluminium & ABS
Mounting Hardware -MaterialsStainless Steel
Wind Rating200 Km/Hr.
Overall Length1.4 Meters
Shipping Length1.5 Meters
Radiating Material6063T6 Aluminum Alloy
Mounting Clamps PositionAt Rear End of Support Boom
Maximum Mount Pipe Diameter 38-62 mm (1.5-2.25 Inches)
Gross Weight20 Kgs.

Environmental Specifications:
Operating Temperature(-) 30 to +70 Degrees Celsius
Storage Temperature(-) 40 to +80 Degrees Celsius
Humidity0 to 95% RH